PE22 / ELC - eta plus electronic GmbH
PE22 / ELC - eta plus electronic GmbH
PE22 / ELC - eta plus electronic GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3 Installation page 8<br />
Connecting the lamp feeder cable<br />
�<br />
The lamp feeder cable must correspond with the cable parameters described in<br />
chapter 6.<br />
<strong>ELC</strong> <strong>PE22</strong>_PE32-V2.2-09.11-GB Subject to technical alterations<br />
Components of the connector:<br />
connector module<br />
crimp contacts<br />
hood<br />
EMC cable gland with<br />
plastic insert<br />
Preparing the lamp feeder cable:<br />
• Remove sheath<br />
• Free m<strong>eta</strong>l braid and put over cable<br />
sheath<br />
• Insulate conductor<br />
7,5<br />
100 12<br />
(measurements in mm)<br />
A suitable contact crimping tool is required of<br />
the type:<br />
Amphenol group C146<br />
Part No.: VN01 025 0029 1C<br />
Closed crimp barrels (individual contacts)<br />
2.5mm
Change language