PE22 / ELC - eta plus electronic GmbH
PE22 / ELC - eta plus electronic GmbH
PE22 / ELC - eta plus electronic GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3 Installation page 19<br />
PROFIBUS-output-data (Master → <strong>ELC</strong>)<br />
Byte-<br />
Nr.<br />
Name [Power<br />
Set<br />
Value]<br />
0 1 2 3 4 5<br />
[Installed<br />
Lamp<br />
Power]<br />
[Lamp<br />
Control]<br />
<strong>ELC</strong> <strong>PE22</strong>_PE32-V2.2-09.11-GB Subject to technical alterations<br />
[Reserved]<br />
To limit the maximum output power, use the register [Installed Lamp Power] (see Fig. 13).<br />
This function is appropriate if the nominal power of the lamp is lower than the nominal power<br />
of the <strong>ELC</strong>.<br />
Lamp power<br />
<strong>ELC</strong>-nominalpower<br />
[Installed Lamp<br />
Power]<br />
20% <strong>ELC</strong>-nominal-power<br />
Fig. 13: Limited output power characteristic<br />
�<br />
20% <strong>ELC</strong>-nominal-power Installed lamp<br />
power<br />
<strong>ELC</strong>-nominalpower<br />
Sollleistungs-<br />
[Power<br />
vorgabe<br />
[Power<br />
vorgabe<br />
Set<br />
Value]<br />
[Power<br />
Value]<br />
[Power Set<br />
Value]<br />
The control characteristic of Fig. 12 comes into effect, if the register [Installed<br />
Lamp Power] is<br />
• not set<br />
• below 20% of <strong>ELC</strong> nominal power<br />
• above <strong>ELC</strong> nominal power