MILLER DURAHOIST The - Honeywell Safety Products
MILLER DURAHOIST The - Honeywell Safety Products
MILLER DURAHOIST The - Honeywell Safety Products
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
USER INSTRUCTIONS - ENGLISH<br />
7.2 100/200 Series Winch<br />
Bracket Assembly & Installation<br />
7.2.3 Mounting the DH-19 to the 100/200 Series Winch<br />
1<br />
Remove<br />
bolt and thumb screw from<br />
100/200 Series Winch. Properly<br />
dispose of bolt, as it will not be<br />
needed. If you are planning on<br />
mounting the DH-19 to a 200 Series<br />
Winch, save the washer.<br />
4<br />
3b<br />
Using a 9/16” box wrench and a 7/32” hex<br />
wrench in conjunction with each other, slide<br />
your hand between the mounting plate and<br />
cable to fasten the nut to the bolt. Tighten<br />
to approx. 20 ft-lbs.<br />
2<br />
Position the DH-19 so that the<br />
bottom bolt is inserted into the top<br />
slot on the back of your 100/200<br />
Series Winch.<br />
5<br />
Apply nut to top bolt on the DH-19<br />
and secure in the same fashion as<br />
in step 4.<br />
3<br />
If<br />
you are mounting the DH-19 to a<br />
100 Series Winch, insert the top bolt<br />
into the corresponding hole (3A). If<br />
you are mounting to a 200 Series<br />
Winch, you will need to use the<br />
provided washer as a spacer (3B).<br />
5a<br />
5b<br />
3a<br />
23