TV EXPLORER HD+ manual - Promax

USER’S MANUAL. TV EXPLORER HD +SensibilityVideo outputSOUNDInputOutputsDemodulationDe-emphasisSubcarrierUSB INTERFACE1 Vpp (75 Ω) positive video.Scart (75 Ω).Scart.Built in speaker, Scart.TV PAL, SECAM, NTSC system according toDVB-T/H, DVB-T2, DVB-C, DVB-S/S2 and MPEGstandards.50 µs, 75 µs (NTSC).Digital frequency synthesis according to the TVstandard.“USB On-the-go” for datalogger and channel planstransfer.- Mass Storage Host: The equipment can read /write on Flash drives.- Serial Port Emulation.- USB CDC: (Communications Device Class).DVB-ASI INTERFACEType1 DVB-ASI input and 1 DVB-ASI output.Connectors Female BNC, impedance 75 Ω.PacketsTransport Stream of 188 or 204 bytes (automaticdetection).TransmissionPacket or burst mode.EXTERNAL UNITS POWERSUPPLYThrough the RF input connector.Terrestrial and Satellite External or 5/13/15/18/24 V.22 kHz signal Selectable in satellite band.Voltage 0.65 V ± 0.25 V.Frequency22 kHz ± 4 kHz.Maximum power 7 5 W.DiSEqC 8 GENERATORAccording to DiSEqC 1.2 standard.POWER SUPPLYInternalBatteries7.2 V 12 Ah Li-Ion battery.Autonomy> 4.5 hours in continuous mode.Recharging time3 hours up to 80% (instrument off).ExternalVoltage 12 V.Consumption 40 W.Auto power off Programmable. After the selected amount ofminutes without operating on any control.Deactivable.English7If you select 5V, the maximum power shall not exceed 2.25 W (450 mA).8DiSEqC TM is a trademark of EUTELSAT01/2011 Page 9