TV EXPLORER HD+ manual - Promax

USER’S MANUAL. TV EXPLORER HD +Figure 67.-You can also access the TS-ASI option from the MEASUREMENT mode. Pressthe key for measurement configuration [17] to access the SETUP menu and go tothe bottom of the menu until the option Enable ASI INTERFACE.Select the option by pressing the rotary and turn it to switch from OFF to ON.Press the rotary to accept the change. Now there is a new option:ASI OUTPUT SOURCE option as explained above, allows selecting the outputbetween two options: DEMODULATORS and AUXILIAR. The option DEMODULATORSuses the TS that comes from the internal demodulator which is active at that time. TheAUXILIARY option uses any video file.5.23 TV Operating ModeWhen pressing the [10] key from any mode of operation the TV EXPLORERHD + accedes to the TV mode, and tries to demodulates on the monitor the currentlyvideo signal on tune.In the monitor will appear the TV picture with a window on the lower part to show,for five seconds whenever the signal is analogue; the channel number, the frequency,the active channel set, the colour system and the TV standard.Page 90 01/2011