TV EXPLORER HD+ manual - Promax

USER’S MANUAL. TV EXPLORER HD +Figure 53.- First Screen.On the X-axis the time variables references are showed. At the bottom rightcorner, the capture elapsed time is displayed, in seconds. At the bottom center theT.span defines the seconds that will be displayed on the screen. For example, if theT.span is 60s, therefore the last 60s captured, will be displayed on the screen. On theleft corner the t variable is at time can be "end - time (s)" or "begin + time (s)".The tag “end” indicates how many seconds you are from the last capture. Toselect this option, go to the configuration menu and select the temporal reference “end”.The tag “begin” indicates how many seconds you are from when starting thecapture. To select this option, go to the configuration menu and select the temporalreference “beginning”.EnglishOn the Y-axis are placed the frequency variables. In this axis the initial and finalfrequencies are showed and depend on the Spectrum Analyser configuration. Forexample if the Spectrum Analyser frequency is 650 MHz and the Spam=100 MHz, theSpectrogram will show as initial frequency 601MHz and end frequency 701MHz.Next to the final frequency the cursor frequency and its signal level are displayed.To move among the parameters press the cursor keys UP or DOWN.To change a parameter, press the arrow keys LEFT or RIGHT or use the rotaryselector.5.16.2.1 Spectrogram ConfigurationBefore the capture begins the options must be configured. Press the key,[17] and an option menu will be displayed.01/2011 Page 73