Toyota TNS410 - PZ420-E0333-EN - TNS410 - mode d'emploi

84 OTHERS
■ When the Camera Is Set to
MANUAL or AUTO
1
Playing a Video through
the Rear View Camera
Hold down the [SCREEN AV/NAV]
button.
● This changes to the rear view camera
screen.
■ When the Camera Is Set to AUTO
● This changes to the rear view camera
screen.
ATTENTION
● The image range displayed on the screen
may vary depending on vehicle or road
surface conditions.
● The image range displayed on the screen is
limited; therefore, you cannot display
something that is located near both ends of
the bumper or under the bumper.
● Colors shown in the rearward image may be
different from the actual colors of the images
shown.
● In the following cases, it may be difficult to
watch the screen, but it is not an error.
• In dark places ( at night, etc.)
• The temperature near the lens is high or
low.
• When there are water drops on the
camera, or when humidity is high (during
rain showers, etc.)
• Foreign substances (mud, etc.) have
become attached to locations near the
camera.
• The camera lens has been exposed
directly to sunlight or the rays of
headlights.
• If a high-intensity point (sunlight reflected
on the vehicle body, etc.) is reflected on
the camera, it may result in a smearing
phenomenon * particular to the CCD
camera.
1 Shift to the back gear.
Point of highintensity
brightness
* Smearing phenomenon: Refers to an
image lag that is caused in the vertical
direction of a high-intensity point (sunlight
reflected on the vehicle body, etc.)
reflected on the camera.