Print RSH-2455 _25 lgs.qxd - Castorama

RSH-2455 _25 lgs..qxd 9/19/03 3:06 PM Page 11
F GB D E I P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT LV SK BG
SERVICE
Servicing requires extreme care and knowledge and
should be performed only by a qualified service technician.
For service we suggest you return the product to your
nearest AUTHORIZED SERVICE CENTRE for repair.
When servicing, use only identical replacement parts.
WARNING
Observe all normal safety precautions related to
avoiding electrical shock.
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator’s manual.
Save this operator’s manual and review
frequently for continuing safe operation and
instructing others who may use this product.
WARNING
The operation of any power tool can result in
foreign objects being thrown into your eyes,
which can result in servere eye damage. Before
beginning power tool operation, always wear safety
goggles or safety glasses with side shields and a
full face shield when needed. We recommend Wide
Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shields. Always
use eye protection.
SAVE THESE INSTRUCTIONS.
SPECIFICATIONS
RSH-2455
Voltage ..................................... 230-240 V (AC) / 50 Hz
Power ................................................................ 2400 W
Max cutting diameter ................................. Max. 40 mm
Notes: The Max Cutting Diameter depends on the
hardness of the wood.
DESCRIPTION
a. Feed Hopper
b. Switch Panel
c. Handle
d. Discharge Chute
e. On/Off switch
English
11
f. Forward/Reverse Selection Knob
g. Live Tool Indicator
h. Over-load Protector
1. Main Body
2. Axle
3. Supporting Leg
4. End Frame
5. Wheel
6. Saddle Washer 8
7. Hex socket screw M8*55
8. Round Screw M5*8
9. Flat Washer
10. Hitch Pin
11. Allen Key
12. Adjusting Hole
13. Lock Washer
14. Spring Washer 8
ASSEMBLY
CAUTION
Assembly of your shredder requires two people.
■ Insert the axle (2) through the holes in each leg (3).
Note: The legs should be angled outwards (Fig. 3)
and the pin holes on the legs should face inside.
■ Turn the shredder upside down (Fig. 4).
■ Insert the leg frame onto the motor housing (Fig. 5).
■ Attach the end frame (4) onto the leg frame.
■ Secure the legs with hex screws (7), spring washer
(14) and a saddle washer (6) for each leg and secure
the end frame with round screws (8) and washers
(13) (Fig. 6). Tighten all nuts and screws.
■ Insert wheels (5) onto the ends of the axle and secure
with washers (9) and hitch pins (10) (Fig. 7).
■ Your shredder is now ready for use.
OPERATION
■ Your shredder is designed to shred organic garden
waste in a private garden. It is not suitable for
shredding glass, metal, plastic or fabric. It should also
not be used for other very hard or very soft material
or for professional use.
■ Plug the shredder into the mains supply. The Live
Tool Indicator (g) will lit. Select forward rotation by
turning the forward/reverse selection knob (f) to the
right. Turn on using the on/off switch (e).
■ To get the maximum service from your shredder,
we recommend that you do not attempt to shred any
twigs or branches over 40 mm in diameter.