Samsung Multifunzione b/n MultiXpress SL-K7400GX (A3) (40 ppm) - User Manual_36.16 MB, pdf, ENGLISH
Samsung Multifunzione b/n MultiXpress SL-K7400GX (A3) (40 ppm) - User Manual_36.16 MB, pdf, ENGLISH
Samsung Multifunzione b/n MultiXpress SL-K7400GX (A3) (40 ppm) - User Manual_36.16 MB, pdf, ENGLISH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Printing on special media<br />
8<br />
Transparency<br />
• Prints made on transparency film with this printer are not compatible with<br />
overhead projectors and may appear as a black and white image if<br />
projected.<br />
To avoid damaging the machine, use only transparencies designed for use in<br />
laser printers.<br />
9<br />
Labels<br />
• In case of color printing using transparencies, the picture quality would<br />
be lower than mono printing when the printouts are used on the<br />
overhead projector.<br />
• Transparencies used in the machine must be able to withstand the<br />
machine’s fusing temperature.<br />
Load the paper with the side to be printed on facing down.<br />
To avoid damaging the machine, use only labels designed for use in laser<br />
machines.<br />
• Place them on a flat surface after removing them from the machine.<br />
• Do not leave unused transparencies in the paper tray for long periods of<br />
time. Dust and dirt may accumulate on them, resulting in spotty printing.<br />
• To avoid smudging caused by fingerprints, handle them carefully.<br />
• To avoid fading, do not expose printed transparencies to prolonged<br />
sunlight.<br />
• Ensure that transparencies are not wrinkled, curled, or have any torn edges.<br />
• Do not use transparencies that separates from the backing sheet.<br />
• To prevent transparencies from sticking to each other, do not let the printed<br />
sheets stack up as they are begin printed out.<br />
• Recommended media: Transparency for a color laser printer by Xerox, such<br />
as 3R 91331(A4), 3R 2780(Letter).<br />
• When selecting labels, consider the following factors:<br />
- Adhesives: The adhesive material should be stable at your machine’s<br />
fusing temperature of about 170°C (338 °F) for 0.1 second.<br />
2. Media and Tray<br />
63