Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Propeller<br />
I THRUST WASHER<br />
MARINE GREASE<br />
45i!i<br />
If the propeller is damaged, replace it<br />
as follows:<br />
ECIAL SPLINE WASHER<br />
PROPELLER<br />
10. MAINTENANCE<br />
COTTER PIN (stainless)<br />
Installation:<br />
Install the thrust washer with the<br />
grooved side toward the gear case, then<br />
install the new propeller in the reverse<br />
sequence of removal.<br />
Removal: Hand tighten the castle nut until the 4<br />
Remove the cotter pin then remove the mm cotter pin can be installed. If<br />
16 mm castle nut, 17 mm plain<br />
necessary, tighten the castle nut just<br />
washer, 10 mm special spline washer, enough to align the hole with the groove<br />
propeller and thrust washer.<br />
in the nut.<br />
Use a new genuine <strong>Honda</strong> cotter pin<br />
and bend the cotter pin ends as shown.<br />
91
Change language