RPL: RAH, Size 077, Vintage C, RoofPak Draw Thru / Blow Thru Air ...

Section N- Main Control Box
Power Panel— Until 3/05
Fan Motor Contactors, Overloads and Fusing
Components, Continued
60 Horsepower Supply or Return Fan Motor- Code 22 or 32= T
Across- The- Line Start (C10= AL)
Sch. Part Part Voltage
Sym.
M9,10
Description
Contactors
Number 208V 230V 380V 460V 575V
M19,20 Contactor- Supply (M10), Return (M20) Fan Motor 027514408 2 2
Contactor- Supply Fan Motor
Fuse Block and Fuses
027514405 2 2 2
FB9,10
FB19,20 Fuse Block- Supply (FB9,10),Return (FB19,20)Fan Motor 023780213 2 2
Fuse Block- Supply Fan Motor 023780210 2 3 2 3 2
Fuse- FB9,10, 19, 20 025860518 6 6
Fuse- FB9,10, 19, 20 025860414 6 3 6 3
Fuse- FB9,10, 19, 20
Overloads and Heaters
025860413 3
OL9,10
OL19,20 Overload- Supply (OL9,10), Return (OL19,20) Fan Motor
Until 1/98 030189400 2 2
Until 1/98 030189300 2 2 2
1/98 and later 059990301 2 2
1/98 and later 059990201 2 2
1/98 and later
Overload Heater- OL9,10, 19, 20
059990101 2
Standard Efficiency Motor (C22= _AY or _GY) 030192500 2 2
Standard Efficiency Motor (C22= _AY or _GY) 022613000 2 2
Standard Efficiency Motor (C22= _AY or _GY)
High or Prem.Eff. Motor (C22= _EY,_FY,_JY,_KY)
022773400 2
1
1/98 and later 059990622 2 2
1/98 and later 059990615 2 2
1/98 and later
LR10,20 Line Reactors
059990614 2
2
NOTE: Quantities Listed are PER motor.
1 For High Efficiency motors used on units built prior to 1/98, see the Overload Heater Chart at the end of this section (located on the
page following the 50HP motors).
2 When the unit has an inverter with bypass (C14= 1, 2, 3, 4, 5, 8) the line reactors are located in the bypass box. When there is no inverter
bypass box the Line Reactors are located in the Main Control Power Panel. The Line Reactor part numbers are listed in Section F.
3 This part number is used for a motor with no inverter. If a 380V or 460V unit has an inverter use fuse block p/n 023780212 and fuse
p/n 025860418.
RoofPak Singlezone; RAH 077 “C” Rev. Q 07/12 RPL 700008300 / Page 191