Power Modular Concept PMC 40
Power Modular Concept PMC 40
Power Modular Concept PMC 40
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Delivery – Transport - Storage<br />
EN 5. Delivery – Transport - Storage<br />
5.1. Introduction<br />
This chapter contains all the necessary information for the correct unpacking, positioning, cabling and<br />
installation of the UPS<br />
The UPS and accessories are delivered on a specifically designed pallet that is easy to move with a forklift or a<br />
pallet jack. Keep the UPS always in upright position and do not drop the equipment. Do not either stack the<br />
pallets because of high-energy batteries involved and the heavy weight.<br />
!<br />
NOTE!<br />
5.2. Receipt of the UPS and visual inspection<br />
If the UPS is not immediately installed the following Guidelines must be<br />
followed:<br />
Transport:<br />
UPS CABINETS and/or battery cabinet CAN FALL OVER. USE THE<br />
SHIPPING BRACKETS ON THE REAR AND FRONT TO SECURE THE<br />
CABINETS. Do not tilt them more than 10° from verti cal, otherwise cabinet<br />
may tip over.<br />
Potential Dangers:<br />
- Tilting the cabinet might damage the system and therefore should no<br />
longer be connected to the mains.<br />
- Weight of the UPS System could cause serious injuries to persons or<br />
anything in the surrounding area.<br />
Storage:<br />
- The UPS should be stored in the original packing and shipping carton<br />
- The recommended storing temperature for the UPS system and batteries<br />
is between +5 °C and +<strong>40</strong>°C.<br />
- The UPS system and the battery sets must be protected from humidity <<br />
90% RF (non-condensing)<br />
Upon receiving the UPS, carefully examine the packing container and the UPS for any sign of physical damage.<br />
The outside ’Tip&Tel’ ( "FRAGILE" and "ARROW") indicator should be intact if the equipment has been<br />
transported in the upright position. In case of rupture or suspect inform immediately:<br />
• The carrier and<br />
• RITTAL GmbH<br />
Ensure that the received UPS corresponds to the material indicated in the delivery note.<br />
The packing container of the UPS protects it from mechanical and environmental damage. To increase its<br />
protection the UPS is wrapped with a plastic sheet.<br />
!<br />
NOTE!<br />
Visible transport damages must be claimed to the carrier immediately after<br />
receipt !!<br />
Other claim for shipping damage must be filed immediately too and the carrier<br />
must be informed within 7 days of receipt of the equipment. The packing<br />
materials should be stored for further investigation.<br />
www.rimatrix5.com<br />
User Guide <strong>PMC</strong> <strong>40</strong> Page 14/67<br />
Modifications reserved