OAO Ivatsevichdrev - Siempelkamp

SIeMpelkAMp | MACHIneRy AnD PLAnts
Paper lay-up Placing of the board on the backing The finished panel is leaving the press
2. KT 700: the new high-end line
According to the motto “More pressure equals more profile”
siempelkamp developed its multi-piston press concept 2011 into a
new high-end model: thanks to the increased pressure of up to
700 n, the Kt 700 opens up the prospect to produce high-quality
and new products in the area of lamination.
“With the Kt 700 sophisticated special products which account
for high-quality eye-catchers can be produced. With this new
press there are hardly any limits for the creativity of the producers
and the demand of the consumers. For example, metal decors
which exhibit an especially noble appearance are in demand. Deep
dramatic 3-D embossing and special colorings are also very popular.
All this is doable with the Kt 700,” says Ulrich Bens. thus, the Kt
700 provides the best equipment for those wood-based panel
manufacturers that want to offer products for a sophisticated
living environment to their customers, for example, in the form of
embossed tiles, wall or ceiling panels.
the special characteristic of the Kt 700 is its multi-piston design
and the new cylinder design. the main benefit, however, is the
considerably increased pressure: this short-cycle press applies up
to 700 n/cm² and is thus able to produce sophisticated products.
siempelkamp also reduced the pressureless exposure time to 0.8
seconds as part of this concept.
the removal of cylinders is now easily possible. the hydraulic tank
which was formerly installed in the center has been replaced with
two left and right mounted hydraulic tanks in the Kt 700.
the innovative mounting of the upper hotplaten results in precise
parallelism of both hotplatens.
the new Kt concept made by siempelkamp also allows flexible
board width adjustment: the customer has control over several
press systems which can be adjusted independently from one
another, and thus receives an especially flexible concept. this highend
model of a siempelkamp short-cycle press has been operating
for egger in France at its Rambervillers location.
3. The smart Eco line – built in cooperation with HAPCO
the customer requirements that are met by siempelkamp’s third
short-cycle press concept are different from those by the Kt 700.
Here the noble appearance of the finished product is of less importance.
the manufacturers that decide to buy the eco line focus on
the solid production of simple furniture and flooring panels
instead.
siempelkamp did not start production of this model on its own:
since 2011 siempelkamp has cooperated with the Chinese machine
and plant builder HAPCo. According to the motto “technological
know-how meets state-of-the-art production,” both partners use
their individual strengths in the production of short-cycle press lines.
the result is the eco line, a performance-strong short-cycle press at
a competitive price. HAPCo manufactures the concept based on
the proven multi-piston design. siempelkamp provides the key
components such as the inline paper lay-up, hydraulics, control
system, cylinders, and electronics as well as the service and warranty.
Panel Plus in thailand is convinced of this combination of
German expertise and Chinese production strength. the company
ordered a 1,950 mm x 2,600 mm short-cycle press of this model.
With a pressure of 400 n/cm², this press performs 120 press cycles
per hour.
60
61