08.06.2013 Views

2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Spot Warning (BSW) indicator lights, located<br />

next to the outside mirrors, when the<br />

radar sensors detect a vehicle in the<br />

detection zone. If the turn signal is<br />

activated in the direction of the detected<br />

vehicle, a chime sounds twice and the BSW<br />

indicator light will flash. (See “Blind Spot<br />

Warning (BSW) system” in the “5. Starting<br />

and driving” section.)<br />

The FCW system will sound a warning<br />

chime and the vehicle ahead detection<br />

indicator light blinks to alert the driver if<br />

the vehicle is traveling close to the vehicle<br />

ahead. (See “Forward Collision Warning<br />

(FCW) system” in the “5. Starting and<br />

driving” section.)<br />

The warning systems switch is automatically<br />

turned on when the engine is started,<br />

and the warning systems ON indicator *1<br />

on the switch illuminates.<br />

To cancel the warning systems, push the<br />

warning systems switch to turn off the<br />

system. The warning systems ON indicator<br />

will turn off.<br />

NOTE:<br />

If you continue to push the warning<br />

systems switch from off to on for over 4<br />

seconds, a chime will sound. This will<br />

2-42 Instruments and controls<br />

change the default status of the LDW, BSW<br />

and FCW systems to OFF so that these<br />

systems will not automatically turn on<br />

when the engine is started. If this procedure<br />

is repeated, the default status will<br />

return to ON.<br />

SNOW MODE SWITCH<br />

SIC3602<br />

For driving or starting the vehicle on snowy<br />

roads or slippery areas, turn on the SNOW<br />

mode switch. The indicator light *1 on the<br />

switch will illuminate. When the SNOW<br />

mode is activated, engine output is controlled<br />

to avoid wheel spin.<br />

Turn off the SNOW mode for normal<br />

driving.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!