2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

ture. (The DUAL indicator light
will illuminate and “DUAL” will
appear on the display.)
. To set separate desired temperatures
for the driver and front passenger,
push the “DUAL” button, the
indicator light illuminates, and then
turn the corresponding temperature
control dial.
. To cancel the separate temperature
setting, push the “DUAL” button, the
indicator light turns off, and the
driver’s side temperature setting will
be applied to both the driver’s and
front passenger’s sides.
A visible mist may be seen coming from the
ventilators in hot, humid conditions as the
air is cooled rapidly. This does not indicate
a malfunction.
Heating (A/C off):
1. Push the “AUTO” button.
(The AUTO indicator light will illuminate
and “AUTO” will appear on the display.)
2. If the A/C indicator light illuminates,
push the “A/C” button.
(The A/C indicator light will turn off.)
3. Turn the temperature control dial to set
the desired temperature.
. When the DUAL indicator light is
turned off:
— Pushing the driver’s side “AUTO”
button changes both the driver’s
and front passenger’s side temperature.
— Pushing the passenger’s side
“DUAL” button changes only the
front passenger’s side temperature.
(The DUAL indicator light
will illuminate and “DUAL” will
appear on the display.)
. To set separate desired temperatures
for the driver and front passenger,
push the “DUAL” button, the
indicator light illuminates, and then
turn the corresponding temperature
control dial.
. To cancel the separate temperature
setting, push the “DUAL” button, the
indicator light turns off, and the
driver’s side temperature setting will
be applied to both the driver’s and
front passenger’s sides.
. Do not set the temperature lower
than the outside air temperature.
Doing so may cause the temperature
not to be controlled properly.
. If the windows fog up, use dehumidified
heating instead of the A/C off
heating.
Dehumidified defrosting/defogging:
1. Push the “ ” button. (The indicator
light will illuminate.)
2. Turn the temperature control dial to set
the desired temperature.
. To remove frost from the outside
surface of the windshield quickly,
set the temperature control and fan
speed control to their maximum
position.
. After the windshield is cleared, push
the “AUTO” button to set to the
automatic mode.
. When the “ ” button is pushed,
the air conditioner will automatically
turn on when the outside air temperature
is above 238F (−58C) to
defog the windshield. The air recirculation
mode will automatically
turn off. The outside air circulation
mode will be selected to improve the
defogging performance.
Monitor, climate, audio, phone and voice recognition systems 4-49