2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

INSTALLING FRONT LICENSE PLATE
STI0569
Use the following steps to mount the
license plate.
Before mounting the license plate, confirm
that the following parts are enclosed in the
plastic bag.
. License plate bracket
. J-nut 6 2
. Screw 6 2
. Screw grommet 6 2
Only use the recommended mounting
position, otherwise an Intelligent Cruise
Control (ICC) sensor obstruction (if so
equipped) may result.
1. Park the vehicle on flat, level ground.
2. Place the license plate bracket with the
positioner *A fit to the bumper pillar
*B and the side end surface of the
bracket aligned with the bumper *C .
3. Mark the center of the hole *D with a
felt-tip pen.
4. Carefully drill two pilot holes using a
0.39 in (10 mm) drill bit at the marked
locations. (Be sure that the drill only
goes through the bumper fascia.)
5. Insert grommets into the hole on the
fascia.
Technical and consumer information 9-13