08.06.2013 Views

2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

2013 Infiniti EX37 | Owner's Manual - Infiniti Owner Portal - Infiniti USA

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

switch.<br />

Depending on the environment or driving<br />

conditions, the auto reverse function may<br />

be activated if an impact or load similar to<br />

something being caught in the moonroof<br />

occurs.<br />

If the moonroof does not operate<br />

If the moonroof does not operate properly,<br />

perform the following procedure to initialize<br />

the moonroof operation system.<br />

1. If the moonroof is open, close it fully by<br />

repeatedly pushing the CLOSE *1 side<br />

of the moonroof switch.<br />

2. Push and hold the CLOSE *1 side of<br />

the moonroof switch to tilt the moonroof<br />

up.<br />

3. Release the moonroof switch after the<br />

moonroof moves slightly up and down.<br />

4. Push and hold the OPEN *2 side of the<br />

moonroof switch to fully tilt the moonroof<br />

down.<br />

5. Check if the moonroof switch operates<br />

normally.<br />

If the moonroof does not operate properly<br />

after performing the procedure above, have<br />

your vehicle checked by an INFINITI retailer.<br />

2-56 Instruments and controls<br />

WELCOME LIGHT<br />

SIC3642<br />

To activate or deactivate the welcome light<br />

function, perform the following procedure.<br />

Note that the function is set to disabled as<br />

the factory default setting.<br />

1. Push the ignition switch to the ON<br />

position.<br />

2. Open the driver’s side door.<br />

3. Within 20 seconds after the ignition<br />

switch is pushed to the ON position,<br />

push the door open request switch on<br />

the driver’s side door handle for more<br />

than 5 seconds with the driver’s door<br />

open.<br />

4. A chime sounds when the setting is<br />

completed.<br />

Once the welcome light function is active,<br />

the puddle light *A and the passenger<br />

cabin illumination will illuminate when you<br />

approach the vehicle with the Intelligent<br />

Key (within approximately 3.3 feet (1 m) of<br />

the antenna built inside the door handles)<br />

and the following conditions are met.<br />

. All doors are closed and locked.<br />

. The ignition switch is in the LOCK or OFF<br />

position.<br />

. The Intelligent Key is outside the<br />

vehicle.<br />

. The puddle light operates within a set<br />

duration.<br />

The welcome light function will be deactivated<br />

automatically if it does not operate<br />

within a set duration to prevent battery<br />

discharge. Note that the duration is set to<br />

14 days.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!