User Manual - Snap Studios
User Manual - Snap Studios
User Manual - Snap Studios
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1 2<br />
1<br />
2<br />
1<br />
2<br />
3 4<br />
5 6<br />
7 8<br />
9 10<br />
11 12<br />
2<br />
1<br />
8<br />
H2-Kit only / H2- Separate items<br />
If your new H2 was supplied in kit form, you will only need to insert the camera<br />
batteries to make it useable immediately. After completing steps 1- 4, you can go<br />
straight to 6-7 and 9-10 (marked in red) and then directly to the section after step<br />
17 to activate the camera. (Please note: if you want to use a rechargeable battery pack<br />
immediately, please see separate instructions under the ‘Camera Body’ heading for use<br />
and then go straight to step 4).<br />
If, however, the equipment was supplied as separate items, you will need to follow<br />
the whole sequence for full assembly and use.<br />
1. Remove the battery holder from the grip by depressing<br />
the battery holder button and simultaneously swinging<br />
the battery holder retaining lever down until it stops. Pull<br />
battery holder downwards.<br />
2. Depress the red button on the battery holder until the<br />
battery cassette is released. Withdraw the cassette from<br />
the holder.<br />
3. Load three CR-123 Lithium batteries into the cassette, ensuring<br />
the polarity of each battery is correctly oriented<br />
(see the ‘+’ markings on the cassette). Re-insert the cassette<br />
into the battery holder, ensuring the red button<br />
clicks back into its retaining position.<br />
4. Holding the battery holder flat against the grip and aligning<br />
the two upper lugs with the slot in the grip, slide it<br />
back into position as far as it will go. Swing back the battery<br />
holder retaining lever until it clicks back into place.<br />
5. Remove the front protective cover from the camera body by<br />
keeping the lens release button depressed and rotating the<br />
cover counter-clockwise until it is released.<br />
6. Remove the lens shade by turning it clockwise.<br />
7. Remove the rear lens cap by unscrewing it in a counterclockwise<br />
direction.<br />
8. Attach the lens to the camera body by firstly aligning the red<br />
index on the lens mount with the red index on the camera<br />
mount. Grip the lens by the metal barrel (not the rubber<br />
focusing ring) and turn it approximately one quarter turn<br />
clockwise until it clicks into place.<br />
9. Remove the front lens cap by pinching together the two<br />
retaining clips.<br />
10. Attach lens shade to lens by aligning the indexes and turning<br />
the shade clockwise a quarter turn.<br />
11. Remove the rear protective cover from the camera body<br />
by pushing the magazine retaining latch to the right and<br />
inwards simultaneously.<br />
If you decide to attach a digital back instead of a film magazine at this point,<br />
please check with the appropriate user manual for details.<br />
12. Remove the protective cover from the film magazine by<br />
placing your thumb on the upper recess and pulling the top<br />
of the cover away from the magazine. Push downwards on<br />
the cover to release the lower catch on the cover from the<br />
magazine retaining bar.