Flowgraph View - Kodak

Calibrating Your Monitor
Supported Hardware
The following hardware is recommended for use with the Display Manager
System.
Generic Monitor Support
The Display Manager System supports many different monitors, but not all
monitors can be calibrated by the system. Most high-quality,
professional-grade monitors can be calibrated.
The first time that you initiate an automatic calibration, you are prompted to
attach a sensor to the monitor so that the system can assess if the monitor
can be calibrated.
NOTE
Before running this evaluation, set your monitor to Expert mode and turn off the
Super Bright mode if applicable.
You are then notified if the monitor can be calibrated. If it cannot, you can
manually adjust your monitor using SMPTE standard procedures and the
supplied colorbars chart. For more information, see “Manual Calibration” on
page 244.
The system runs this evaluation whenever you attach a different monitor and
then initiate automatic calibration.
Enable Cable (USB Cable ECC 1)
An enable cable is required to transfer data from your monitor to your
computer. Obtain this cable from outside suppliers.
230 KODAK Look Manager System User Guide V2.2