Flowgraph View - Kodak

Troubleshooting Monitor Calibration
Dark Gain Correction Failure
Dark Gain Correction may fail if light enters the sensor.
If Dark Gain Correction fails:
1. Click OK on this message and also on the initialization message that
appears next.
2. Restart the process that you were running when you were prompted to
perform the Dark Gain Correction - either Calibrate, Characterize, or
Verify.
3. When prompted for the Dark Gain Correction, place the sensor on a dark
surface where light cannot reach it.
Do not attach it to the monitor.
Cover it with a dark cloth, if necessary.
4. Repeat the Dark Gain Correction.
Sensor Does Not Adhere to Screen
SEQUEL Sensor
When attaching the sensor, press firmly but not too hard.
Clean the sensor. Use alcohol and a lint-free cloth to clean the suction cups
and sensor face.
Clean the monitor. Use a monitor cleaning kit or a soft cloth with a solution
designed to clean monitors.
If the sensor continues to fall off, wet the suction cups with alcohol before
attaching to the monitor.
X-RITE DTP92+EK Sensor
Firmly push on the sides of the sensor so that the spring-loaded suction cup
slides forward onto the screen. When the suction cup is firmly in place,
release the sensor.
You may need to moisten the suction cup by wiping it with a tissue lightly
dampened with water, or to fog the suction cup by breathing on it.
You may need to clean the monitor and su ction cup, if the sensor does not
firmly attach. Clean the suction cup with a clean, dry cloth.
IMPORTANT
Do not apply a cleanser to the suction cup.
To clean the monitor, use a soft, lint-free paper or cloth lightly dampened
with a mild glass cleaner.
268 KODAK Look Manager System User Guide V2.2