CL100 / CL300 Service Manual - Welch Allyn

More documents

Recommendations

Info

PHOTO 7 PHOTO 8 36 35 34 37 1-24 WELCH ALLYN 38 32 33 39
CL 300 SURGICAL ILLUMINATOR Symptom Cause Remedy Lamp fails to start and fans are not running. Lamp fails to start and fans are running. Lamp shuts off after operating for a few minutes and restarts after cooling. Indicator light on and lamp shuts off Replacement Lamp will not seat into Light Source No power to unit Check power supply cord and outlet Line voltage is
Page 1 and 2: PN: LB-MAN-CLSERV Rev. A Service Ma
Page 3 and 4: Table of Contents GENERAL INFORMATI
Page 5: GLOSSARY OF TERMS - - - - - - - - -
Page 8 and 9: SERVICE CENTERS If you have an equi
Page 10 and 11: SYSTEM SYMBOL DESCRIPTIONS 5A, 250V
Page 12 and 13: OPERATING INSTRUCTIONS CONTROLS POW
Page 14 and 15: PRINCIPLES OF OPERATION LIGHT SOURC
Page 16 and 17: TOOLS REQUIRED Slotted screwdriver,
Page 18 and 19: Symptom Cause Remedy Low light outp
Page 20 and 21: If the location of the defects move
Page 22 and 23: 7. Remove the two white lamp cable
Page 24 and 25: 2. Remove the nut from the wire tie
Page 26 and 27: Part Number Description Photo # Bub
Page 28 and 29: PHOTO 3 PHOTO 4 19 12 10 11 7 40 22
Page 32 and 33: Symptom Cause Remedy Low light outp
Page 34 and 35: If the DMM reading does not match,
Page 36 and 37: 6. Remove the 4 screws from the pow
Page 38 and 39: 2. Remove the screws securing the c
Page 40 and 41: 6. Installation is the reverse proc
Page 42 and 43: CL 300 SURGICAL ILLUMINATOR REPAIR
Page 44 and 45: PHOTO 1 PHOTO 2 9 10 11 2 3 4 8 7 6
Page 46 and 47: PHOTO 5 PHOTO 6 37 43 44 42 38 47 4
Page 48 and 49: GLOSSARY OF TERMS AC Alternating Cu
Page 50 and 51: 2. After the fifteen (15) minute bu
Page 52 and 53: THEORY OF OPERATION LIGHT SOURCE Th
Page 54: CL 300 SURGICAL ILLUMINATOR CIRCUIT

CL100 / CL300 Service Manual - Welch Allyn

Create successful ePaper yourself

Delete template?

Save as template?