POSITIP 855 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH
POSITIP 855 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH
POSITIP 855 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
I - 4 Programming <strong>POSITIP</strong><br />
Hole patterns in programs<br />
8<br />
5 0 ENT<br />
5 0 ENT<br />
3 0 ENT<br />
Center point Y ?<br />
Starting angle ?<br />
5 ENT<br />
Program blocks<br />
Number of holes ?<br />
ENT<br />
Center point X ?<br />
2 0 ENT<br />
Radius ?<br />
Enter the radius of the bolt circle (RAD = 20 mm).<br />
Confirm your entry.<br />
Hole depth ?<br />
Enter the number of holes (NO. = 8).<br />
Confirm your entry.<br />
Enter the X coordinate of the bolt circle center (CCX = 50 mm).<br />
Confirm your entry.<br />
Enter the Y coordinate of the bolt circle center (CCY = 50 mm).<br />
Confirm your entry.<br />
Enter the starting angle from the X axis to the first hole (START = 30°).<br />
Confirm your entry.<br />
Enter the hole depth (DEPTH = –5 mm).<br />
Confirm your entry.<br />
Choose No entry for the hole depth if (for example) the holes<br />
will be drilled to different depths.<br />
0 BEGIN PGM 20 MM Start of program, program number, unit of measurement<br />
1 Z+20.000 Clearance height<br />
2 CYCL 1.0 FULL CIRCLE Cycle data for a full circle follow<br />
3 CYCL 1.1 NO. 8 Number of holes<br />
4 CYCL 1.2 CCX +50.000 X coordinate of the center of the bolt circle<br />
5 CYCL 1.3 CCY +50.000 Y-coordinate of the center of the bolt circle<br />
6 CYCL 1.4 RAD 20.000 Radius<br />
7 CYCL 1.5 START +30.000 Starting angle of first hole<br />
8 CYCL 1.6 DEPTH –5.000 Hole depth<br />
9 Z+20.000 Clearance height<br />
10 END PGM 20 MM End of program, program number, unit of measurement<br />
For a circle segment (CYCL 2.0 CIRCLE SEGMENT),<br />
you also enter the angle step (STEP) between the holes<br />
(after the starting angle).<br />
The bolt hole circle is then executed in the EXECUTE PROGRAM<br />
operating mode.<br />
<strong>POSITIP</strong> <strong>855</strong> Operating Instructions 57