POSITIP 855 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH
POSITIP 855 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH
POSITIP 855 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
I - 4 Programming <strong>POSITIP</strong><br />
Rectangular pocket milling in programs<br />
Program blocks<br />
0 BEGIN PGM 55 MM Start of program, program number, unit of measurement<br />
1 CYCL 5.0 RECT. POCKET Cycle data for cycle 5.0 RECTANGULAR POCKET<br />
2 CYCL 5.1 START 2 Starting position above the workpiece surface<br />
3 CYCL 5.2 DEPTH – 20 Milling depth<br />
4 CYCL 5.3 POSX + 50 Pocket center in X<br />
5 CYCL 5.4 POSY + 40 Pocket center in Y<br />
6 CYCL 5.5 LGTHX 80 Side length in X<br />
7 CYCL 5.6 LGTHY 60 Side length in Y<br />
8 CYCL 5.7 DIR. 0 :CLIMB Climb milling<br />
9 CYCL 5.8 FIN.AL 0.5 Finishing allowance<br />
10 END PGM 55 MM End of program, program number, unit of measurement<br />
Cycle 5.0 RECTANGULAR POCKET is then run in the EXECUTE PRO-<br />
GRAM operating mode (see Chapter I-5).<br />
62 Operating Instructions <strong>POSITIP</strong> <strong>855</strong>
Change language