DUAL ®& DUAL ® SH SINGLE ®& SINGLE ® SH - Expert-CM

SERVICE (cont.)
START SWITCHES
1⁄2 gal 1 gal 1 1⁄2 gal
READY SELECTOR
ON / WARMER START
FIG. 38 START SWITCHES
1⁄2 gal 1 gal 1 1⁄2 gal
START ON / WARMER SELECTOR READY
Location:
The momentary start switches are located on the
front of the hood next to the on/off switches.
Test Procedure:
1. Disconnect the brewer from the power source
and remove the wires from both terminals of the
switch.
2. Check for continuity across the two terminals on
the switch when it is held in the lower position.
Continuity must not be present across these terminals
in the upper position.
If continuity is present as described, reconnect the
wires, the switch is operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Remove wires from the switch terminals.
2. Compress the clips inside the hood and gently
push the switch through the opening.
3. Push the new switch into the opening and spread
the clips to hold the switch in the hood.
4. Refer to Fig. 39 when reconnecting the wires.
P792
Page 35
WHI/YEL to
Timer #5
WHI/ORG to
Timer #3
ORN to Left Timer TL3 (Electro/
mechanical)
RED/BLK to Interlock Assy (Electronic)
YEL to Left Timer TL5
WHI/ORN to Right Timer TL3 (Electro/mechanical)
BRN/BLK to Interlock Assy (Electronic)
WHI/YEL to Right Timer TL5
DUAL BREWERS
WITH RELAY (Prior to S/N SNG0014000)
GRN to Server
Power Relay "A"
WHI/VIO to ON/OFF Switch
and Brew Timer TL1
WITHOUT RELAY(After S/N SNG0014000)
SINGLE BREWERS
FIG. 39 START SWITCH TERMINALS
P801
BLK To SH Transformer
#1
BLK to On/Off
Switch
P1386
41976 031709