UD-35 SERVICE UPDATE FIRST HALF—2009 - Whirlpool
UD-35 SERVICE UPDATE FIRST HALF—2009 - Whirlpool
UD-35 SERVICE UPDATE FIRST HALF—2009 - Whirlpool
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CABINET & DOOR ISSUES<br />
DOORS OUT OF ALIGNMENT –SXS & FDBM<br />
Condition: Doors are not aligned at top, RC or FC door is higher. RC is pre-set to<br />
be 1.5mm higher than FC at factory, under assumption food load will level them out.<br />
•<br />
Service Fix:<br />
-Check door gaps between RC and FC at top and bottom.<br />
If door out of align and gaps are uneven, loosen hinge screws for door that<br />
is lower, pull top of door toward hinge and hold as you re-tighten the hinge<br />
screws. See figure 1<br />
-If gaps are even or parallel, take clip off of bottom hinge bushing and use<br />
wrench to raise and lower door height. A combination of raising one door<br />
and lowering another should be enough to fix most door alignment issue. Be<br />
sure to check door seal after adjustment. See figure 2<br />
Figure 1<br />
CAB/DOOR ADJUSTMENT RANGE<br />
49<br />
Clip<br />
Figure 2<br />
Right to left – Each door has 10mm, (.4 inches) of total movement right to left. However,<br />
this varies the height by 3mm. There should be a gap of approx. 6mm, (.2<br />
inches) between doors. The top hinge has enough right movement to move too far<br />
to the right causing light switch arm to hit side trim, so always check for interference<br />
when done adjusting. No left right movement in bottom hinge.<br />
Up and down – The bushing on the bottom hinge allows for 10mm, (.4 inches) of<br />
adjustment.<br />
In and out – Top hinge tap plate allows for 5.5mm, (.2 inches) of in and out movement.<br />
No bottom hinge movement.