UD-35 SERVICE UPDATE FIRST HALF—2009 - Whirlpool
UD-35 SERVICE UPDATE FIRST HALF—2009 - Whirlpool
UD-35 SERVICE UPDATE FIRST HALF—2009 - Whirlpool
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
Drawer out of plane side to side<br />
• First make sure it is not the RC door<br />
w/ the issue. Easiest way to check<br />
is to open RC door and look down at<br />
the gasket gap across the top of the<br />
FC Drawer. If the gasket looks more<br />
compressed on one side than the<br />
other it is an FC issue. If Door to product<br />
gap looks even for FC, proceed w/<br />
earlier shim insertion for RC bottom<br />
hinge.<br />
•<br />
It is ok to horizontally slot the Drawer<br />
bracket holes, but by no more than a<br />
¼” on each side. Maker sure when<br />
re-inserting bolts adequate torque is<br />
applied to keep this bolts tight and further<br />
movement of drawer alignment.<br />
DRAWER NOT CLOSING<br />
Make sure Door to basket nuts are on the inside and bolt heads are on the outside.<br />
Check for frost or obstructions along Evaporator cover in back of drawer.<br />
Remove Ice and Crisper Pans to make sure it is not obstructing closing.<br />
Adjust tilt of door if top or bottom of drawer is hitting breaker first.<br />
Make sure drawer is not hitting side trim.<br />
All else fails replace basket and or slides.<br />
DOOR NOISE – PRIMARILY LIGHT SWITCH EXT. ARM<br />
ASSEMBLY<br />
Condition: Popping noise or squeak when cycling door.<br />
Service Fix: Remove screw and add Loc-tite 222MS from approved List, to screw<br />
thread and re-insert.<br />
Add grease to nylon bushing to fix squeak or moan.<br />
Adjustment Holes<br />
New Screws w/ serrated head<br />
54<br />
Nylon Bushing