English - StellarSupport - John Deere

Auxiliary Control Configuration Changed
This message occurs when the system detects an Auxiliary
Control and that configuration has been modified during
run time (e.g. additional input and/or implement added).
Press “Enter” key F to navigate to the home page. Go to
the Auxiliary Controls page by pressing the “Controls” key
G to review or change the Auxiliary Control assignments.
Auxiliary Control Enabled
This message occurs when the operator enables the
Auxiliary Control manually. Press “Enter” key F to navigate
to the home page. Go to the Auxiliary Controls page by
pressing the “Controls” key G to review or change the
Auxiliary Control assignments.
Auxiliary Control Enabled
This message occurs when Auxiliary Control has been
enabled manually, however, not all assignments have
been completed successfully. Press “Enter” key F to
navigate to the home page. Go to the Auxiliary Controls
page by pressing the “Controls” key G to review or change
the Auxiliary Control assignments.
Safety Signs
PC13155 —19—17FEB11
RN38933,0000136 -19-21SEP11-2/4
PC13146 —19—17FEB11
RN38933,0000136 -19-21SEP11-3/4
IMPORTANT: If the “Enter” key F is selected, the
implement only follows the assignments which
have been completed successfully, however,
there are still assignments which are not
complete. It is necessary to review the Auxiliary
Controls mapping screen by pressing the
“Controls” key G and complete all assignments
before enabling Auxiliary Controls. PC13153 —19—17FEB11
10-2
RN38933,0000136 -19-21SEP11-4/4
112912
PN=12