English - StellarSupport - John Deere

MACHINE and IMPLEMENT tabs
MACHINE tab allows setup of the following:
• Machine Type—Used to select machine type.
• Machine Model—Used to distinguish between different
models.
• Machine Name—Used to distinguish between multiple
machines of the same model.
• Connection Type—Drawbar or 3 pt. hitch.
• Machine Turn Radius
• Turning Sensitivity
• Recording Source—Used to determine when recording
turns on-off.
• Machine Offset—Used to eliminate skips or overlaps
due to an offset receiver.
NOTE: Not all recording sources are available
for all machines. Many recording sources
require ground speed.
Recording Source
NOTE: If Manual Mode is selected, the operator must
push the Record or Pause Button to turn recording
on or off for Documentation and Coverage Maps.
The following control units can be used with AUTO to turn
recording on and off automatically :
• John Deere Harvest Monitor
• John Deere SeedStar for Air Carts
• John Deere SeedStar Gen 2 Monitor or Variable Rate
Drive for Planters
• John Deere SprayStar Gen 4
• John Deere Central Insecticide System
• Raven 440, 450, 460, 660
• SideKick
• GreenSeeker
• Rawson Accu-Rate and Accu-Plant
• New Leader Mark III Mark IV
• Dickey-John Seed Manager
• Vanguard PIC Seed Monitor
• Task Control Unit compliant implements
NOTE: Dual Variety Function cannot be used with
a three motor VRD planter
NOTE: PTO, Hitch, and SCV can be used as a recording
source on certain vehicles only.
SeedStar is a trademark of Deere & Company
SprayStar is a trademark of Deere & Company
Raven is a trademark of Raven
GreenSeeker is a trademark of NTech Industries, Inc.
Rawson is a trademark of Rawson
Accu-Rate is a trademark of Rawson
Accu-Plant is a trademark of Rawson
New Leader is a trademark of New Leader
Dickey-John is a trademark of Dickey-John
Vanguard is a trademark of Vanguard
GreenStar General
45-4
Recording Source
A—Manual Recording On/Off
B—Automatic (from controller)
C—Rear PTO
D—3-point Hitch
E—Front PTO
F— Implement Switch Open
G—Implement Switch Closed
H—SCV 1
I— SCV 2
J— SCV 3
K—SCV 4
IMPLEMENT tabs allow setup of the following:
• Implement Type—Used to select machine type.
• Implement Model—Used to distinguish between
different models.
• Implement Name—Used to distinguish between
multiple machines of the same model.
• Implement Offsets—Used to eliminate skips or overlaps
due to an off-center or drafting implement.
• Implement Widths
For more information, see MACHINE AND IMPLEMENT
SETUP section.
PC8770 —UN—11OCT05
CZ76372,00002A0 -19-30MAR11-1/1
112912
PN=42