English - StellarSupport - John Deere

Front of Display
LED (B) indicates power mode of display:
Cold boot progress bar is black with a yellow background.
Cold boot-up occurs when the GS3 display has been
powered down for over 6 hours or loses unswitched
power. It takes 60-80 seconds to power up.
Warm boot progress bar is yellow with a black
background.
Warm boot-up occurs when the GS3 display has been
operating in the last 6 hours and has NOT lost unswitched
power during that time. It takes 20-30 seconds to power
up.
Shutting Down or Standby mode LED is orange.
IMPORTANT: If LED is FLASHING ORANGE and the
screen is blank, an out of range temperature
condition is detected. Turn unit off to prevent
damage to the display.
Operating Temperature Range
-20° to 70° C (-4° to 158° F)
Storage Temperature
-40° to 85° C (-40° to 185° F)
Status of the LED is green when display is on, orange
when display is starting up and shutting down. If the LED
is RED, the unit is not operational. Turn unit off. The
display has encountered an error or issue and is working
to recover.
IMPORTANT: Always clean screen display with power
off. Cleaning screen while operating could
result in unintended button selections.
Getting Started
15-2
A—Display
B—LED (Power Light)
display
C—USB Connections
To clean display, power down and wipe screen with a soft
cloth sprayed with a non-ammonia based cleaner such as
John Deere glass or multipurpose cleaner.
USB connection used to transfer data to and from display
and also updating software. Most USB drives will work
with the display.
NOTE: The display has two USB connections for
redundancy in case one was to fail. Only one
USB drive may be inserted at a time. The
USB connections are meant for data transfer
and reprogramming only.
PC12701 —UN—20JUL10
CZ76372,0000283 -19-12JAN11-1/1
112912
PN=14