Hx1-Hx2 Manual-1.4.1 - Telos
Hx1-Hx2 Manual-1.4.1 - Telos
Hx1-Hx2 Manual-1.4.1 - Telos
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
26 | section 4<br />
Receive AGC and Noise Gate Configuration settings<br />
SETTINGS Bits #7 and #8 jointly control the operation of the receive AGC and Noise Gate<br />
processing functions. You can select how aggressively low level signals are brought up to the<br />
nominal (+4 dBu) level using the following bit settings:<br />
SETTINGS<br />
Bit 7 Bit 8 Configuration Setting Value<br />
OFF OFF Phone AGC = OFF, Noise Gate = OFF<br />
OFF ON Phone AGC = 1/2 Full, Noise Gate = OFF<br />
ON OFF Phone AGC = Full Noise Gate = OFF [Factory Default]<br />
ON ON Phone AGC = Full Noise Gate = Normal<br />
Auto-Answer Configuration settings<br />
OPTIONS Bits #3 and #4 jointly control the operation of the Auto-Answer feature of the<br />
hybrid. You can select between turning the feature off, or set the number of rings before the<br />
incoming call is answered and the placed on air as follows:<br />
OPTIONS<br />
Bit 3 Bit 4 Configuration Setting Value<br />
OFF OFF Auto-Answer = OFF, [Factory Default]<br />
OFF ON Auto-Answer = ON, Auto-answer after first ring<br />
ON OFF Auto-Answer = ON Auto-answer after third ring<br />
ON ON Auto-Answer = ON Auto-answer after eighth ring<br />
Send extra gain to caller configuration setting<br />
The <strong>Hx1</strong> and <strong>Hx2</strong> hybrid units have been designed to send a -9 dBu average level to the<br />
telephone line, to meet the USA’s FCC regulations. OPTION Bit #5 adds 3dB of gain to the<br />
send level heard by the caller. This should only be used when the hybrid is connected to a PBX<br />
or in countries outside of the USA that permit a higher transmit level.<br />
OPTIONS<br />
Bit 5 Configuration Setting Value<br />
OFF No additional gain is applied [Factory Default]<br />
ON +3 dB additional gain is applied to the audio sent to the caller