Hx1-Hx2 Manual-1.4.1 - Telos
Hx1-Hx2 Manual-1.4.1 - Telos
Hx1-Hx2 Manual-1.4.1 - Telos
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
32 | section 4<br />
Factory Default Configuration Settings<br />
These settings will work in most cases and should be considered to be a “starting point”.<br />
The following is the Factory Default Configuration for the SETTINGS, OPTIONS, and<br />
Internal Telephone Network/Call Progress Tone Detection (CPTD) DIP switches:<br />
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8<br />
SETTINGS OFF OFF OFF OFF OFF ON ON OFF<br />
Bits 1 and 2 EQ LO, fixed dB gain adjustment => 0 dB gain<br />
Bits 3 and 4 EQ HI, fixed dB gain adjustment => 0 dB gain<br />
Bits 5 and 6 Ducker dB gain adjustment => -6 dB ducking<br />
Bits 7 and 8 AGC and Noise Gate settings => AGC is FULL, Noise Gate is OFF<br />
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8<br />
OPTIONS ON OFF OFF OFF OFF OFF OFF OFF<br />
Bits 1 and 2 DDEQ configuration => Dynamic EQ is enabled<br />
Bits 3 and 4 Auto-Answer configuration => feature is OFF<br />
Bit 5 Send gain to phone => feature is OFF<br />
Bit 6 <strong>Hx2</strong> internal mix-minus enable => feature is OFF<br />
Bit 7 Feedback Reduction enabled => feature is OFF<br />
Bit 8 Reserved<br />
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8<br />
INTERNAL OFF OFF OFF OFF OFF OFF OFF OFF<br />
Bits 1 through 4 Telephone Network configuration => USA, Canada<br />
Bits 5 through 8 Call Progress Tone Detection => USA dial tone