AUTO-CUT 300 - Victor Technologies
AUTO-CUT 300 - Victor Technologies
AUTO-CUT 300 - Victor Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Cutting Machine / Gantry<br />
Cutting Table<br />
1/0<br />
Ground Cable<br />
(F1)<br />
Earth Ground<br />
Rod<br />
Remote Arc<br />
Starter (RAS-1000)<br />
Cutting Machine / Gantry<br />
Cutting Table<br />
1/0<br />
Ground Cable<br />
(F1)<br />
Earth Ground<br />
Rod<br />
Torch<br />
1/0<br />
Ground Cable<br />
Customer supplied<br />
CNC<br />
Device<br />
0 - 10 ft (0 - 3 m) Ideal<br />
20 ft (6 m) Maximum<br />
Remote Arc<br />
Starter (RAS-1000)<br />
Star Ground on Cutting Table<br />
Torch<br />
CNC<br />
Device<br />
0 - 10 ft (0 - 3 m) Ideal<br />
20 ft (6 m) Maximum<br />
Power Supply<br />
Gas Control Module<br />
Primary location<br />
1/0 Work Cable<br />
1/0 Ground Cable<br />
‘Star’<br />
Ground<br />
Star Ground on Cutting Table<br />
1/0<br />
Ground Cable<br />
Customer supplied<br />
#4 AWG<br />
Ground<br />
(F)<br />
Gas Control Module<br />
Power Supply<br />
1/0 Work Cable<br />
‘Star’<br />
Ground<br />
Ultra-Cut<br />
or<br />
Auto-Cut O2<br />
Note: The gas control module can<br />
be mounted on top of the power<br />
supply.<br />
If it is, it should be grounded<br />
directly to the power supply with<br />
#4 AWG ground, (F).<br />
This alternate location requires<br />
grounding the power supply to the<br />
‘Star’ ground with the 1/0 Ground<br />
Cable (F1).<br />
Auto-Cut W/RAS<br />
#4 AWG Ground (F)<br />
(Factory Installed)<br />
Art # A-08253_AC<br />
Manual No. 0-4817 Auto-Cut <strong>300</strong> 3-8 INSTALLATION