AUTO-CUT 300 - Victor Technologies
AUTO-CUT 300 - Victor Technologies
AUTO-CUT 300 - Victor Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5.01 General Maintenance<br />
SECTION 5: MAINTENANCE<br />
Perform the following checks periodically to ensure proper system performance.<br />
Power Supply Maintenance Schedule<br />
Daily<br />
Check coolant level; add coolant as needed.<br />
Check gas hose connections and pressures.<br />
Check cooling fan; clean as needed.<br />
Monthly<br />
Check cooling fan and radiator; clean as needed.<br />
Check gas hoses for cracks, leaks, or abrasion.<br />
Replace as needed.<br />
Check all electrical connections for cracks or<br />
abrasion. Replace as needed.<br />
Clean water filter (if using H2O Mist)<br />
Six Months<br />
Replace coolant filter.<br />
Clean coolant tank.<br />
Vacuum out any dust buildup inside power supply.<br />
5.02 Coolant Filter Cleaning Procedure<br />
Periodic cleaning of the coolant filter ensures maximum coolant flow efficiency. Poor coolant flow causes inefficient<br />
torch parts cooling with consequent faster consumable wear.<br />
Clean the coolant filter as follows:<br />
1. Disconnect system from main input power.<br />
2. Unscrew and remove the filter bowl by hand. Be sure to keep the O-ring.<br />
3. Remove and clean the filter. Re-install the bowl, tightening it by hand. Be sure the O-ring is in place.<br />
4. Turn the system on and check for leaks.<br />
Manual No. 0-4817 Auto-Cut <strong>300</strong> 5-1 MAINTENANCE
Change language