Operator and Installation Manual Tron AIS TR-8000.pdf - Jotron

More documents

Recommendations

Info

10.1.3.3.5.1 Illegal Coordinates Example: Too large value for Latitude 10.1.3.3.5.2 Region Width /Height problem Example: Too large value for “Region width” TR-8000 Operator and Installation Manual 76
10.1.3.4 Alarms Red square shows button selected to get to next menu 10.1.3.4.1 Alarm Popup When Alarms occurs, a popup will be shown with status of Alarms: And the “Alarm” popup must be acknowledged by pressing the button below Alarm window TR-8000 Operator and Installation Manual 77
Page 2 and 3:
Table of Contents 1 Revision Histor
Page 4 and 5:
8.3.1.2 Label in transponder with c
Page 6 and 7:
1 Revision History Revision no. By
Page 8 and 9:
3 Introduction 3.1 Safety Instructi
Page 10 and 11:
4 Operation general introduction Th
Page 12 and 13:
6 TR-8000 Description The Tron AIS
Page 14 and 15:
6.2 Transponder Unit The Transponde
Page 16 and 17:
6.2.5 External Display (Ethernet) C
Page 18 and 19:
7 Operational description The opera
Page 20 and 21:
7.2 Display Unit menu system. Statu
Page 22 and 23:
7.2.4 Important Buttons shown in di
Page 24 and 25:
7.2.6 Ship List The display unit re
Page 26 and 27: 7.2.7 Graphical View The graphical
Page 28 and 29: 7.3 Voyage Settings Red square show
Page 30 and 31: 7.3.2 Destination The destination o
Page 32 and 33: 7.3.6 Draught The Draught parameter
Page 34 and 35: 7.4.2 Popup when received message E
Page 36 and 37: 7.4.4.1 Message recipients “From
Page 38 and 39: 7.5 Display Settings Red square sho
Page 40 and 41: 8.1.2 Display Unit The display unit
Page 42 and 43: 8.1.2.3 Flush/ Panel Mounting Figur
Page 44 and 45: 8.1.3.1 GPS Antenna When selecting
Page 46 and 47: 8.1.3.2 VHF Antenna When individual
Page 48 and 49: 8.2.2 VHF antenna The table below s
Page 50 and 51: 8.3.1 Transponder In order to conne
Page 52 and 53: 8.3.1.2 Label in transponder with c
Page 54 and 55: 8.3.1.4 Sensor connections Sensors
Page 56 and 57: 8.3.1.6 Pilot / Aux. Display connec
Page 58 and 59: 8.3.1.8 Detailed description of con
Page 60 and 61: 8.3.2 Display Unit: The TR-8000 Dis
Page 62 and 63: Transponder (RJ45): Figure 8-20 Eth
Page 64 and 65: - Not subject to target loss due to
Page 66 and 67: 10.1.1.1 Type of Vessel Select Type
Page 68 and 69: 10.1.2 Display Settings Red square
Page 70 and 71: 10.1.3.2 View Regions It is possibl
Page 72 and 73: 10.1.3.3.1 Change Channel NOTE! BE
Page 74 and 75: 10.1.3.3.3 Output Power The button
Page 78 and 79: The internal Alarm is triggered if
Page 80 and 81: 032 Heading lost/invalid External h
Page 82 and 83: 10.1.4 Indicators Red square shows
Page 84 and 85: 10.2.1.1 Display/ Transponder IP NO
Page 86 and 87: 10.2.1.3 Aux. Display/Pilot Port Re
Page 88 and 89: 10.2.1.5 Priorities From this menu
Page 90 and 91: 10.2.2 VHF link/Long Range Red squa
Page 92 and 93: 10.2.2.5 Test Communication The Com
Page 94 and 95: 10.2.4 Internal GPS Red square show
Page 96 and 97: 10.2.6 Self Test Red square shows b
Page 98 and 99: 10.2.8 Current position Red square
Page 100 and 101: 12 List of VHF Channels Channel Fre
Page 102 and 103: 14 Outline Drawings 14.1 TR-8000 Tr
Page 104 and 105: 14.3 TR-8000 Display Unit, Flush/Pa
Page 106 and 107: 14.5 Procom CXL 2-1LW/h Maritime VH
Page 108 and 109: 14.7 SANAV - GPS Marine Antenna Fig
Page 110 and 111: 15 Abbreviations and Definitions AC
Page 112 and 113: RCC RF RMS ROT RNG RX SAR S/N SOG S
Page 114 and 115: 16 Service Procedure WARRANTY CLAIM
Page 116 and 117: 16.2 Trouble Description Form For b
Page 118 and 119: 18 List of Figures Figure 7-1 Trans
show all

Operator and Installation Manual Tron AIS TR-8000.pdf - Jotron

Create successful ePaper yourself

Delete template?

Save as template?