16CH Embedded Net DVR Standalone - Footprint Security
16CH Embedded Net DVR Standalone - Footprint Security
16CH Embedded Net DVR Standalone - Footprint Security
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CAUTION<br />
! The lightning flash with arrowhead symbol, within an equikateral<br />
triangle, is intended to alert the user to the presence of uninsulated<br />
“dangerous voltage” within the product’s enclosure that may be of<br />
sufficient magnitude to constitute a risk of electric shock to persons.<br />
WARNING<br />
This exclamation point witin an equilateral triangle is intended to<br />
alert the user to the presence of important operating and<br />
maintenance (servicing) instructions in the literature accompanying<br />
the appilance.<br />
➣Install this equipment avoiding a direct ray of light, heats and<br />
moistures where may result in lowering efficiency, electric<br />
shock or fire.<br />
➣Do not pull electric wire or don’t touch power plug with wet hands<br />
Can result in electric shock for fire.<br />
➣Do not disassemble, repair or convert this product without permission.<br />
Can result in electric shock or fire. When repair is required,<br />
contact the service center or local distributor.<br />
➣Operation Temperature/Humidity 0~40℃/ under 90% RH;<br />
Power input AC115V/230V<br />
➣Do not expose this equipment to rain or moisture to prevent<br />
electric shock and risk fire hazards<br />
➣Do not use Power source other than that specified (IEC6065/CNS1319)<br />
➣Key away the flammable material or fire to avoid any hazard.<br />
➣Install the product on a well-ventilated place; retain the enough<br />
distance from the rear panel to the wall.<br />
➣Power disconnect: Units with or without ON-OFF switches have<br />
power supplied to the unit whenever the power cord is inserted<br />
into the main source; However, the unit is operational only when<br />
the ON-OFF switch is in the ON position. To disconnect it from the<br />
main source, you have to disconnect the power cord.<br />
➣In case of touching PCB Board, please use proper ESD protection<br />
equipment.<br />
<strong>16CH</strong> <strong>Embedded</strong> <strong>Net</strong> <strong>DVR</strong> <strong>Standalone</strong><br />
02