EMC32 / AMS32 V8.52 Release Note - Rohde & Schwarz

EMC32-S Section
6 EMC32-S Section
6.1 Extensions
●
●
Field Probes
o The leveling algorithm will now apply an appropriate correction factor for the field sensor
measurement values when the measurement is done with pulse modulation on during
leveling. It is assumed that the field probe sensor is a RMS detector.
Support for EMS test with two radiation antennas on different positions
o When using several radiation antennas to cover the complete test frequency range and a
turntable for the EUT positioning, EMC32 could set the appropriate EUT azimuth position
automatically when changing the active radiation antenna. This is configured via the
following parameters in the antenna properties dialog
●
●
Remove Nogo Lines
o The NOGO points in the immunity level graphics in an existing EMS test result are removed
when the frequency point is re-measured and no further NOGO occurs
Field uniformity report improved
o The following points are improved in the field uniformity report:
- identical subfolder structure for all file types used (graphics, tables)
- report setup file kept
- RC target file name used as root subfolder name
6.2 Improvements
●
●
●
Subrange gap on wrong position in result table
o A subrange gap in the result table was set to one row to early. This issue has been fixed
Check on loading of EUT monitoring template whether devices referenced in the
monitoring channels exist
o Now a check on loading of the EUT monitoring template is performed whether the
referenced devices exists.
Interlock
o EMC32 now can be exit correctly if a new test was generated with accidentally no interlock
device defined in the device list.
Rohde & Schwarz 9