EMC32 / AMS32 V8.52 Release Note - Rohde & Schwarz
EMC32 / AMS32 V8.52 Release Note - Rohde & Schwarz
EMC32 / AMS32 V8.52 Release Note - Rohde & Schwarz
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>EMC32</strong>-K2 Wireless Section<br />
8 <strong>EMC32</strong>-K2 Wireless Section<br />
8.1 Extensions<br />
●<br />
●<br />
●<br />
●<br />
CMU200 Handover: try to setup a new call when the handover fails<br />
o CMU200 driver: Implemented now is to try to setup a call in the new band when the<br />
handover fails. This includes GSM interband and GSM - WCDMA and vice versa.<br />
o The same behavior is applied if the intraband handoff fails.<br />
CMU200 optimization for ABT measurement<br />
o The remote logging is switched off in ABT calibration (both DL and UL) in order to get<br />
maximum level before EUT noise cancellation is decreasing the level.<br />
EMS: frequency calculation for the excluded frequency bands has changed<br />
o The frequency calculation algorithm now includes the excluded frequency band corner<br />
frequencies to the measurement and restart the frequency stepping calculation after the<br />
excluded frequency range.<br />
o The excluded frequency range editor allows now deactivate unused frequency bands and<br />
keep them in the list.<br />
Bluetooth supported as Mobile Phone band for testing Bluetooth Headsets<br />
Bluetooth is now implemented a mobile network standard and provides:<br />
o ABT measurements on Bluetooth devices e.g.: BT headsets<br />
o <strong>EMC32</strong> is extended for a mobile phone band Bluetooth in the EUT Info file.<br />
o CBT with Audio option, and modification for that into <strong>EMC32</strong>.<br />
8.2 Improvements<br />
●<br />
EUT Monitoring: Output warning if template uses a ABT offset variable like ABTREFUL<br />
but has no CMU configuration action<br />
o<br />
When running an ABT measurement and using variables like ABTREFUL{Offset Value<br />
Uplink} there must be a Set Device Test Start action in order to get the mobile band and fill<br />
the variable appropriately.<br />
<strong>Rohde</strong> & <strong>Schwarz</strong> 11