EMC32 / AMS32 V8.52 Release Note - Rohde & Schwarz
EMC32 / AMS32 V8.52 Release Note - Rohde & Schwarz
EMC32 / AMS32 V8.52 Release Note - Rohde & Schwarz
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>EMC32</strong>-K10 EMI Auto Test<br />
10 <strong>EMC32</strong>-K10 EMI Auto Test<br />
10.1 Extensions<br />
●<br />
●<br />
●<br />
●<br />
●<br />
●<br />
MIL-STD 461C Tests support Antenna Polarizations<br />
o The EMI auto tests for MIL-STD 461 C (with optional NB/BB discrimination) as well as for<br />
MIL-STD 461 D/E/F now enable to maximize over both antenna polarizations (radiated<br />
emissions tests with antennas only).<br />
Force a receiver preset between test phases<br />
o Because of the many optimizations concerning the programming of the receivers, in an EMI<br />
AT only at the start of a test a preset will occur. The many mode changes and parameter<br />
changes during an EMI AT might make a receiver unstable. Therefore a receiver preset<br />
occurs before each test phase:<br />
- before preview meas.<br />
- before zoom1 meas.<br />
- before max. meas.<br />
- before zoom2/adjustment/finall meas.<br />
EMI Auto Test Editor: enable to alternatively start with hor. Polarization<br />
o In the EMI autotest editor: with Preview > Measurements Accessories > Polarization an<br />
alternatively start with hor./vert. Polarization can be chosen.<br />
Online help<br />
o New flow charts showing Auto Test are added to the online help.<br />
Interactive Data Reduction for Final Measurement with final results from other tests<br />
o It is possible to set the parameter "Interactive Data Reduction before the final<br />
measurement" in the limit lines dialog when the data reduction subdialog is disabled due to<br />
starting the test without preview measurements but with final results from another test.<br />
NSA Measurement<br />
o User messages for repetition of the reference measurement improved.<br />
10.2 Improvements<br />
●<br />
●<br />
Editor Zoom Measurement: doesn't allow to activate a zoom template without selecting<br />
template name<br />
o The EMI AT editor does not allow to save the following setting: activate a zoom scan /<br />
sweep template but with no selected template.<br />
Turn device out of property limits<br />
o<br />
It is now possible to generate a new test if the position of the turn device is outside the<br />
device properties limits.<br />
<strong>Rohde</strong> & <strong>Schwarz</strong> 13