Ancho Manual V69_1 Full Page for PDF.pub - QRS Music Technology

For Technical Support Call 1-800-247-6557
Optional - Sliding Mounting Bracket
Ancho V69_1
Snap the narrow edge [A] of a plastic slide [3] into the sliding bracket’s slot [B].
Repeat on the other side of the sliding bracket.
Lower the sliding bracket [2] over the Ancho controller [1] as shown in Figure 1 below.
The narrow edge [A] of the plastic slides should touch the Ancho controller.
Insert a screw [5] through hole [C] of the plastic slide [3]
Align and tighten the screw into the threaded hole [C] of Ancho.
Repeat on the other side.
Place a plastic latch [4] over the plastic slide [3] with the catch [E] facing Ancho. See Figure
2.
The larger hole of the latch aligns over the screw [C] that was inserted in the previous step.
Insert a screw [5] through the smaller hole [D] of the plastic latch [4] and the plastic slide
[3].
Align and tighten the screw into the threaded hole [D] of Ancho [1].
Repeat on the other side.
Use the paper template to mark the position under the keybed for the mounting holes [F].
Attach the bracket to the keybed using the #8 screws and connect the cables. See Page 6.
Pull Ancho out until the plastic latches snap into place.
To close, spread the plastic latches as shown below and push Ancho under the keybed.
Item # Description QTY
98400A
980007
Ancho
Controller
980007A
Sliding
Bracket
1
990050 Plastic Slide 2
990048
70592
Sliding Bracket
Complete
1
Plastic Latch 2
M3 x 14mm
Screw
#8 x 3/4”
Screw-Black
4
4
1
2
3
4
5
6
Q R S M U S I C T E C H N O L O G I E S PAGE 53