3100B HFOV Operator Manual - CareFusion
3100B HFOV Operator Manual - CareFusion
3100B HFOV Operator Manual - CareFusion
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
54 <strong>3100B</strong> <strong>HFOV</strong><br />
WARNING<br />
Do not attempt to substitute a circuit configuration from any other instrument. Use of a non-3100A or a non-<strong>3100B</strong><br />
circuit can result in injury to the patient or to the operator, and it may cause damage to the equipment. The Patient<br />
Circuit described in this manual is specifically designed for patient use with the Model <strong>3100B</strong> <strong>HFOV</strong>.<br />
Obtain an External Air/O2 Blender and an External Humidifier for incorporation into the system as<br />
described in Chapter 3. Attach these devices to the Patient Circuit using the attachment accessories<br />
supplied and using Figures 5.1 and 5.2 as a guide. The following connections must be made:<br />
Device Input Connection(s) From Output Connection To<br />
Air/O2 Blender (a) Hospital Air Control Package rear<br />
DISS connection<br />
panel “INLET FROM<br />
(b) Hospital Oxygen<br />
BLENDER” DISS fitting<br />
DISS connection<br />
Humidifier Control Package rear panel Patient Circuit<br />
“OUTLET TO HUMIDIFIER”<br />
Bias Flow Connection<br />
3/8" barbed fitting 3/8" nipple fitting<br />
There is an additional connection from the Hospital AIR DISS connection to the Column DISS Air fitting<br />
marked “AIR COOLING.”<br />
Simpson<br />
doodle<br />
Blender/Cooling Gas<br />
Filter Replacement Record<br />
Filters should be replaced every<br />
500 hours of operation<br />
00879<br />
Elapsed Time<br />
BREATING GAS<br />
OUTLET TO<br />
HUMIDIFIER 40-60 PSI<br />
MAXIMU 60 LPM<br />
<strong>3100B</strong> OSCILLATORY VENTILATOR<br />
POSITION LOCK<br />
* Sensor<br />
COOLING AIR<br />
"Outlet to Humidifier"<br />
3/8" Barbed Fitting<br />
"Inlet From Blender"<br />
DISS Fitting<br />
Driver Replacement Record<br />
Drivers should be replaced every<br />
2000 hours of operation<br />
"Cooling Air"<br />
DISS Fitting<br />
Figure 6.3. Rear Panel Connections.<br />
WARNING<br />
Do not shorten the 30" bias flow tube provided with the patient circuit, as this may reduce the maximum ∆P by<br />
allowing the oscillatory pressures to be attenuated by closer proximity to the volume of the humidifier canister.<br />
767164–101 Rev. R