3100B HFOV Operator Manual - CareFusion

3100B HFOV 63
Chapter 8 Maintenance and Troubleshooting
This chapter covers the Model 3100B maintenance and troubleshooting procedures with which the
operator and service technician should be acquainted.
Note
CareFusion or its official representative will make available upon request such circuit diagrams, component part lists,
descriptions, calibration instructions or other information which will assist factory-qualified technical personnel to repair those
parts of the equipment which are classified as repairable. If you are interested in factory training, please contact the
CareFusion Service Department for scheduling and pricing of our biomedical training classes.
WARNING
Failure to comply with the recommended maintenance procedures described in this chapter could result in injury
to the patient or operator or could result in damage to the equipment.
Exterior Cleaning
When you need to clean the outside surfaces of the 3100B, we recommend using a weak disinfectant
liquid to wipe down the exterior of the instrument. Do not spray liquid cleaners directly on the exterior
surface; spray the cleaning cloth and wring it nearly dry before wiping. Do not allow liquids to drip into
the instrument.
Note
Do not use alcohol or sterilization liquids on the exterior surface of the 3100B.
Do not use abrasive cleaners or solvents on the exterior surface of the 3100B
Operator Maintenance Procedures
The operator maintenance procedures are:
Emptying the Water Trap.
Changing the Compressed-gas Inlet Filter Cartridge Elements.
Changing the Power Failure Alarm battery.
Cleaning the Column Lint Filter.
Changing the Patient Circuit.
767164–101 Rev. R