Service Source Power Mac G5 - Retrocomputing.net

More documents

Recommendations

Info

4. If you are replacing the drive with a new drive, transfer the four hard drive guide screws from the sides of the original drive to the replacement drive. 5. If you are installing an additional drive, remove the four guide screws from the left side of the hard drive bay and screw them into the sides of the new drive. Serial ATA Hard Drive Power Mac G5 Take Apart - 7
Replacement Note: When replacing the top drive, make sure the guide screws align with the middle slot of the drive bay, and then gently push the drive into the bay until it snaps into place in the top position. When installing a bottom drive, align the guide screws with the bottom slot of the drive bay and slide the drive in until it snaps into place. 8 - Power Mac G5 Take Apart Serial ATA Hard Drive
Page 1 and 2: apple Service Source Power Mac G5 U
Page 3 and 4: Overview Power Mac G5 is a 64-bit d
Page 5 and 6: What’s New Overview PowerPC G5—
Page 7 and 8: Video The Power Mac G5 computer com
Page 9 and 10: apple Service Source Take Apart Pow
Page 11 and 12: Opening the Computer Tools No tools
Page 13 and 14: 3. Remove the air deflector and pla
Page 15: Procedure 1. Release the drive lock
Page 19 and 20: Procedure 1. Disconnect the optical
Page 21 and 22: 6. If you are replacing the drive w
Page 23 and 24: Front Inlet Fan(s) The front inlet
Page 25 and 26: 2. If you are replacing the fan(s)
Page 27 and 28: Memory (DIMMs) Depending on the mod
Page 29 and 30: Procedure 1. Locate the DIMM slots
Page 31 and 32: 33 MHz PCI slots and cannot use PCI
Page 33 and 34: AirPort Extreme Card Only the AirPo
Page 35 and 36: Battery Tools No tools are required
Page 37 and 38: Rear Exhaust Fan(s) Tools The follo
Page 39 and 40: 4. If you are replacing the fans, u
Page 41 and 42: Speaker/Fan Assembly Tools The only
Page 43 and 44: 4. If you are replacing the fan, us
Page 45 and 46: Procedure 1. Remove the two screws
Page 47 and 48: Procedure 1. Remove the two Bluetoo
Page 49 and 50: Procedure 1. Remove the metal G5 ca
Page 51 and 52: Replacement Note: If you are replac
Page 53 and 54: Procedure 1. Route the modem filter
Page 55 and 56: Replacement Note: Make sure the mod
Page 57 and 58: Procedure 1. Disconnect the black a
Page 59 and 60: Front Panel Board Cable Tools No to
Page 61 and 62: PCI Card Guide Tools The only tool
Page 63 and 64: Power Supply Tools The only tools r
Page 65 and 66: 4. Remove the four power supply mou
Page 67 and 68:
Air Deflector Sensor Board Tools Th
Page 69 and 70:
Logic Board Tools The only tools re
Page 71 and 72:
5. Carefully tilt the logic board u
Page 73 and 74:
12. Install the modem filter board
Page 75 and 76:
Replacement Procedure 1. Temporaril
Page 77 and 78:
PCI Divider Tools The only tools re
Page 79 and 80:
3. Remove the modem filter board ca
Page 81 and 82:
Thermistor Cable Tools The only too
Page 83 and 84:
Front Inlet Fan Cable Tools The onl
Page 85 and 86:
Front Panel Board Tools The only to
Page 87 and 88:
3. Carefully pull the board a short
Page 89 and 90:
Power Button Tools The only tools r
Page 91 and 92:
4. Lift up and remove the power but
Page 93 and 94:
apple Service Source Troubleshootin
Page 95 and 96:
PCI and AGP Cards The Power Mac G5
Page 97 and 98:
Block Diagram General Information P
Page 99 and 100:
Pinouts Power Supply P1 Connector P
Page 101 and 102:
Front Inlet Fan Connector Pin# Sign
Page 103 and 104:
Optical and Serial ATA Hard Drive C
Page 105 and 106:
No power (LED on/off, no fans, no b
Page 107 and 108:
Modem 1. Replace modem 2. Replace m
Page 109 and 110:
Exploded Views Exploded View 1 Supe
Page 111 and 112:
Internal Views Overview Optical Dri
Page 113 and 114:
External Views Front View Optical D
show all

Service Source Power Mac G5 - Retrocomputing.net

Create successful ePaper yourself

Delete template?

Save as template?