Samsung ME40C User Manual - Touch Screens Inc.

Chapter 08
System
Multi Control
MENUm → System → Multi Control → ENTERE
Multi Control
ID Setup
ID Input
MDC Connection
DisplayPort daisy chain
00
--
RS232C MDC
--
The displayed image may differ depending on the model.
Clone
Configuring settings for Multi Control
••
ID Setup
Assign an ID to a set. (Range: 0~99)
Press ▲ or ▼ to select a number, and press E.
••
ID Input
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
••
MDC Connection
Select a method to connect to MDC to receive the MDC signal.
--
RS232C MDC: Communicate with MDC via the RS232C-stereo cable.
--
RJ45 MDC: Communicate with MDC via the RJ45 cable.
••
DisplayPort daisy chain
To display the DP IN video input through the DP OUT output port, select a device connection method from Single Stream
Transport (SST) and Multi Stream Transport (MST).
Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on two display devices
connected.
――
If Clone is selected, the PC recognizes the two displays as a single monitor.
――
Clone mode is enabled if the input source is a digital input other than DisplayPort, such as DVI, HDMI or MagicInfo.
Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two display devices connected.
――
If Expand is selected, the PC recognizes the two displays as separate monitors.
――
The mode functions only on a PC that supports DisplayPort 1.2 MST.
――
For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.
120