Samsung ME40C User Manual - Touch Screens Inc.

Chapter 04
Using MDC
Configuring Settings for Multi Control
MENUm→ System → Multi Control → ENTERE
Assign an individual ID to your product.
Configuring settings for Multi Control
••
ID Setup
Assign an ID to a set. (Range: 0~99)
Press ▲/▼ to select a number, and press E.
••
ID Input
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
••
MDC Connection
Select a method to connect to MDC to receive the MDC signal.
--
RS232C MDC
Communicates with the MDC via a RS232C MDC cable.
--
RJ45 MDC
Communicates with the MDC via an RJ45 MDC cable.
••
DisplayPort daisy chain
To display the DP IN video input through the DP OUT output port, select a device connection
method from Single Stream Transport (SST) and Multi Stream Transport (MST).
Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on
two display devices connected.
――
If Clone is selected, the PC recognizes the two displays as a single monitor.
――
Clone mode is enabled if the input source is a digital input other than DisplayPort, such as
DVI, HDMI1, HDMI2, or MagicInfo.
Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two
display devices connected.
――
If Expand is selected, the PC recognizes the two displays as separate monitors.
――
The mode functions only on a PC that supports DisplayPort 1.2 MST.
――
For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.
56