AT Command Reference - Stollmann
AT Command Reference - Stollmann
AT Command Reference - Stollmann
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Stollmann</strong><br />
E+V GmbH<br />
BlueRS+ - SPP<br />
<strong>AT</strong> <strong>Command</strong> <strong>Reference</strong><br />
Mode<br />
Description<br />
0 No sniff support<br />
1 Passive sniff support<br />
2 Active sniff support<br />
Passive sniff support means that the device accepts sniff requests from the remote<br />
device with an interval between the values of <strong>AT</strong>**BSMIN and <strong>AT</strong>**BSMAX. To<br />
accept sniff requests from the remote device bit 2, of the <strong>AT</strong>**BLINKP parameter<br />
must to be set.<br />
If active sniff support is enabled, the device tries to setup a sniff interval with a value<br />
of <strong>AT</strong>**BSMAX.<br />
Note: The performance of the command is influenced by the parameters<br />
<strong>AT</strong>**BLINKP, <strong>AT</strong>**BSMIN and <strong>AT</strong>**BSMAX.<br />
Examples:<br />
at**bsmode=1 and<br />
at**blinkp=5<br />
at**bsmode=2 and<br />
at**blinkp=1<br />
Sniff requests from remote devices will be accepted<br />
Device tries to initiate sniff mode on the Bluetooth link<br />
BSNAME<br />
<strong>AT</strong> syntax:<br />
Configurator syntax:<br />
<strong>AT</strong>**BSNAME | <strong>AT</strong>**BSNAME=<br />
bsname | bsname=<br />
Local Service Name<br />
This command defines the service name of the BlueRS+ serial port. The service<br />
name is shown on a remote Bluetooth terminal device during a service discovery<br />
sequence.<br />
Examples:<br />
at**bsname=serial port<br />
at**bsname=RS+SrvName<br />
Own service name of the serial port is “serial port”<br />
Own service name of the serial port is “RS+SrvName”<br />
BSNAME2<br />
<strong>AT</strong> syntax:<br />
Configurator syntax:<br />
Local Second Service Name<br />
<strong>AT</strong>**BSNAME2 | <strong>AT</strong>**BSNAME2=<br />
bsname2 | bsname2=<br />
This command defines the service name of the second BlueRS+ serial port. The<br />
service name is shown on a remote Bluetooth terminal device during a service<br />
discovery sequence.<br />
Examples:<br />
at**bsname2=serial port<br />
at**bsname2=RS+2ndSrvName<br />
Own service name of the serial port is “serial port”<br />
Own service name of the serial port is “RS+2ndSrvName”<br />
Author: ta Date of Saving: 18.01.07 Ref: BlueRS+_<strong>AT</strong>_<strong>Command</strong>_<strong>Reference</strong>.doc Revision: 2.02 Page 30 of 54