AT Command Reference - Stollmann

Stollmann
E+V GmbH
BlueRS+ - SPP
AT Command Reference
This command sets the password for the remote configuration port. The length of
the password can be 1...32 characters. The default password is empty - just press
the return key to access.
RSTMSG
AT syntax:
Configurator syntax:
AT**RSTMSG | AT**RSTMSG=
rstmsg | rstmsg=
Startup Message
After power-on, the following startup message can be displayed with a fixed speed
of 9,600 bps, 8 data bits, no parity, 1 stop bit:
+++ Press ,,, to enter BlueRS+ configurator +++
Mode
Description
0 Inactive, no startup message will be send after power-on
1 Active, startup message will be send after power-on
RSTTIM
Startup Timer
AT syntax:
Configurator syntax:
AT**RSTTIM | AT**RSTTIM=
rsttim | rsttim=
This command defines the startup delay after a reset. Within this period, the internal
configuration mode can be entered after a reset of the device (see AT**RSTMSG).
Value
n=3…255
Description
Startup delay n*100 ms
40 Startup delay 4 s
S
AT S Register
AT syntax:
Configurator syntax:
AT**Sx | AT**Sx=
sx | sx=
This command configures the S register settings. It is used in the AT command set
only.
Mode
sx
Description
Show the current setting of register Sx
sx=1 Set register Sx to 1
Author: ta Date of Saving: 18.01.07 Ref: BlueRS+_AT_Command_Reference.doc Revision: 2.02 Page 42 of 54