AT Command Reference - Stollmann

Stollmann
E+V GmbH
BlueRS+ - SPP
AT Command Reference
RBACCL
AT syntax:
Configurator syntax:
Remote Config Port Access Level
AT**RBACCL | AT**RBACCL=
rbaccl | rbaccl=
This command defines the accessibility and visibility of the Bluetooth remote
configuration port.
Mode
Description
0 Config port is neither accessible nor visible
1 Config port is accessible but not visible
2 Config port is accessible and visible
RBSNAME
AT syntax:
Configurator syntax:
Remote Config Port Service Name
AT**RBSNAME | AT** RBSNAME=
rbsname | rbsname=
This command defines the service name of the Bluetooth remote configuration port.
The service name is shown on a remote Bluetooth terminal device during a service
discovery sequence.
Examples:
at**rbsname=config port
at**rbsname=RS+CfgName
Own service name of config port is “config port”
Own service name of config port is “RS+CfgName”
RESET
Reset Device
AT syntax:
Configurator syntax:
AT**RESET
reset
This command resets the whole functionality of the BlueRS+ by a forced hardware
reset (like power off/on).
Note: See also the AT**RSTTIM parameter.
RIDLE
AT syntax:
Configurator syntax:
Idle Data Timeout for Remote Connection
AT**RIDLE | AT**RIDLE=
ridle | ridle=
This command defines the timeout (in seconds) for disconnecting the remote
Bluetooth link after inactivity on the serial line.
Author: ta Date of Saving: 18.01.07 Ref: BlueRS+_AT_Command_Reference.doc Revision: 2.02 Page 40 of 54