USER'S MANUAL - DATAQ Instruments

CHAPTER 3 Settings and Measurement
(10) Data replay menu
Data replay menus are displayed by pressing the MENU key during replay.
Cursor
Position
Setting
Selections available
Move to First Data Press right key to execute.
Move to Last Data Press right key to execute.
Move to Center Press right key to execute.
Move to Method:
Position, Time
Selected Position
[Position] Position 0 to end of data
For example, if the sampling interval is 100 ms, capture desti-
nation is the built-in RAM, and the number of capture points
is 10000, settings up to 9999 ms are available.
[Time] Date Date from the start to end of the data
Time Time from the start to end of the data
Cursor Synch
Off, On
Data search CH CH1 to 200, Logic, Pulse, Alarm
* Logic and Pulse are displayed only if the Logic Pulse function
is On in the AMP settings.
Statistical
calculation
between
cursors
[CH1 to CH200] CH1-200
[Logic]
Logic1-4
[Pulse]
Pulse1-4
[Alarm]
Alarm1-4
Mode [CH1 to CH200] ↑H, ↓L
[Logic]
↑H, ↓L
[Pulse]
↑H, ↓L
[Alarm]
Both, ↑H, ↓L
Level [CH1 to CH200] Set numeric value
Set numeric value
Find Next Press right key to execute.
Find Previous Press right key to execute.
Function
Off, Average, Max, Min, Peak, RMS
Execute Press right key to execute.
(10)-1 Move to First Data
Executing this option moves the currently selected cursor (A or B) to the start of the data.
(10)-2 Move to Last Data
Executing this option moves the currently selected cursor (A or B) to the end of the data.
(10)-3 Move to Center
Executing this option moves the currently selected cursor (A or B) to the center of the data.
3−47