Download our Equipment Solutions Brochure (14 MB) - Tech-Rentals

www.techrentals.com.au
Data & Telecommunications
LAN/WAN Analysers cont’d.
JDSU SmartClass 10M-1G Ethernet Tester
JDSU,CSC-ETHTR-PC (3249)
AU
SmartClass Ethernet for comprehensive installation, turn up and maintenance
of Ethernet IP services up to 1 Gbit. Performs Bidirectional RFC 2544,
Asymmetric RFC and multiple streams testing. Applications include
performance assessment of Carrier Ethernet services, activation and
maintenance of metro Ethernet networks, deployment of active Ethernet
(point-to-point) access services, traffic generation and QoS verification.
JDSU SmartClassEthernet 10M-1G Ethernet Tester
JDSU,SMARTCLASS-ETH (3220)
AU
Two SmartClass Ethernet(s) provided for comprehensive installation, turn up
and maintenance of Ethernet IP services up to 1 Gbit. Performs Bidirectional
RFC 2544, Asymmetric RFC and multiple streams testing. Applications
include performance assessment of Carrier Ethernet services, activation
and maintenance of metro Ethernet networks, deployment of active Ethernet
(point-to-point) access services, traffic generation and QoS verification.
PDH/SDH Analysers
JDSU ANT 5 SDH/PDH Access Tester
JDSU,ANT5-STM4 (3445)
AU/MY
Field tester for the installation, commissioning
and fault finding of fibre and copper SDH/PDH
networks. Electrical interfaces for PDH/SDH:
E1, E3, DS3, E4, STM-0e/1e; Optical interfaces
for SDH/SONET: STM-1/OC-3, STM-4/OC-12.
BERT, round trip delay measurement, error performance analysis: G.821,
G.826, G.828, G.829, M.2100,M.2101 and ANSI. Autoconfig functionality for
automatic traffic detection, line rate, structure and mapping. Offline Viewer
SW provides result analysis and report generation.
PDH/SDH Analysers cont’d.
JDSU ANT 5 SDH/PDH Access Tester
JDSU,ANT5-STM16 (3446)
AU/MY
SField tester for the installation, commissioning and fault finding of fibre and
copper SDH/PDH networks from 1.5Mb/s to 2.5 Gb/s. Optical testing at dual
wave lengths at STM-1, STM-4, and STM-16. Electrical testing at DS1/E1/E3/
DS3/E4 and STM-1 interfaces. Full analysis of concatenated mappings. ATM
analysis for service verification of ATM and 3G/UMTS networks.
JDSU EDT-135 E1 and Data Tester
JDSU,EDT-135 (3450)
AU/MY
Field service tester for commissioning,
maintenance and troubleshooting of E1
PCM2Mbps and V.11/RS-442, V.24/RS-232,
V.35,V.36/RS-449, EIA-530 data circuits
operating at 50bps to 2Mbps. Provides framed
& unframed monitoring, end-to-end testing, drop
& insert, channel associated signalling; error & alarm analysis, S bit, NFAS
& NMFAS monitoring & generation. Round trip delay measurement, G.821,
G.826 & M.2100 quality of service measurements. Signal level measurement
& primary multiplexer testing.
Acterna MTS 8000/T-BERD Transport Module
JDSU,MTS8000
MY
Multirate interface for PDH-DS1/DS3/E1/E3/E4,STS-1 OC-3/12/48/48, STM-
1e/1/4/16 and interface for OC-192 STM-64 with the ability to monitor down
to the STS-1 level inside of any supported optical rate. Used for verifying and
qualifying the performance of SDH and Gigabit ethernet, telecommunications
networks. Electrical and optical interfaces at rates 1310/1550nm). Also supports
the NewGen (ethernet over Sonet/SDH) and able to perform RFC2544.
Ethernet IP testing with 10/100/100Mbps electrical RJ-45 Interfaces. Supports
VLAN, Q-in-Q,VPLS,MPLS Tunnelling application. Comes with touch screen
GUI operation. Measures optical power and frequency. Floppy drive installed.
COMPACT.
POWERFUL.
INTUITIVE.
Introducing Uncompromising
Tablet-Inspired Handheld OTDRs,
the MAX-700B series.
Outdoor-enhanced
touchscreen
7” 1sec
12 HOURS
Intuitive,
Windows-like GUI
Improved navigation
and performance
Rugged enough
for any OSP
environment
Ready to test
in 1 second
Never-let-youdown
battery life
2Gb
Store up to
20 000 traces
(bellcore)
iOLM Ready: Turn
complex OTDR analysis
into a one-touch task
Three models to cover the most common fiber test applications
› MAX-715B Last-Mile OTDR
› MAX-720B Access OTDR
› MAX-730B FTTH/PON OTDR
www.EXFO.com/MaxOTDR