Sony - TSL

2.5.1 Direct Tallies
These are tallies coupled directly to a UMD or Tally LED panel. They may be derived, for example, from the
parallel closures from a Vision Mixer via the D37 connector on the System Controller.
There is the capability of lighting the left and right tallies on the UMD from separate tally signals – i.e. split
tallies.
Split Tallies
To set Direct Tallies
• Highlight the required Display.
• Enter in the left lower box the left tally assignment. The right tally assignment is filled automatically when
the OK button is pressed.
• If a split tally arrangement is required, enter the tally number before selecting the OK button.
• Map any Tally Lamps on the Desktop (the hardware being LEDs on panels) to the appropriate Tally
Output by RH Mouse clicking on the Tally Lamp on the Desktop. The actual LED will have to be hardwired
to the appropriate D37 Tally Output connector.
» Direct tallies may also be entered by selecting the Display on the Desktop with the RH mouse button
and then selecting Set Direct Tally from the menu.
» Direct tallies have preference over router-associated tallies. This means that a UMD that has a direct
tally mapped to it which may be OFF, will not show a tally LED lit even if a live router-associated tally
is also mapped to that UMD.
The right tally must always have a tally number entered. It is not possible to assign only a left tally to a UMD.
If a RH tally is not required it may be disabled via the following procedure.
WinSoft V 4.2.4.0 27 Issue 5.3